Configuring An Ipv6 Policy; Creating An Ipv6 Node; Configuring Match Criteria For An Ipv6 Node; Configuring Actions For An Ipv6 Node - HP 5500 EI series Configuration Manual

Tasks at a glance
(Required.)
•
Configuring IPv6 local PBR
•
Configuring IPv6 interface PBR

Configuring an IPv6 policy

Creating an IPv6 node

Step
1. Enter system view.
2. Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.

Configuring match criteria for an IPv6 node

Step
1. Enter system view.
2. Enter IPv6 policy
node view.
3. Configure an ACL
match criterion.
4. Configure a packet
length match
criterion.
NOTE:
Implementation of the permit or deny action and the time range of the specified ACL that an ACL match
criterion uses depends on the device model.

Configuring actions for an IPv6 node

Step
1. Enter system view.
2. Enter IPv6 policy
node view.
3. Set an IP
precedence.
Configuring IPv6 PBR:
Command
system-view
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
Command
system-view
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
if-match acl { acl6-number | name acl6-name }
if-match packet-length min-len max-len
Command
system-view
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
apply precedence { type | value }
386
Remarks
N/A
By default, no IPv6 policy
node is created.
Remarks
N/A
N/A
By default, no ACL
match criterion is
configured.
By default, no packet
length match criterion
is configured.
Remarks
N/A
N/A
By default, no IP precedence is
specified.