Heated grip, removing and installing
on right
–
Remove handlebar trim
–
Remove instrument trim
....................................................See Group 46
a
•
Disconnect plug (1)
•
Open cable ties (arrows)
•
Remove wiring harness from bracket on handle-
bar
1
3
•
Remove fasteners (arrows)
•
Fold back rear section of combination switch (3)
•
Lift front part of combination switch (1) slightly to
the front whilst simultaneously detaching the
heated throttle twist grip (2) from the combina-
tion switch
•
Slide heated throttle twist grip (3) to the right and
release Bowden cable from curved washer
•
Remove heated throttle twist grip
When installing:
•
e
Ensure that lines and Bowden cable are routed cor-
1
rectly!
Install combination switch with the antitwist mecha-
nism in the correct location.
Ensure adequate clearance between combination
switch and brake fitting!
C1320140
•
•
2
Adjustment data:
Move the handlebars all the way from left to right
and ensure that throttle valve does not move
X
Combination switch mount............................. 4 Nm
C1320150
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
Attention:
Secure front section of combination switch in
socket (arrow)
Checking throttle cable play, adjusting if neces-
sary
Torque specification:
C1320061
32.7