Removing And Installing Angled Lever; Removing And Installing Needle Roller Bearings And Needle Roller Races In Angled Lever; Removing Needle Roller Bearings And Needle Roller Races - BMW F 650 GS Repair Manual

Removing and installing
33 53 200
angled lever
•
Slacken the nut of the fastener securing the strut
to the angled lever (3).
•
Slightly raise the rear wheel and withdraw
fastener (3).
•
Remove the fastener securing the angled lever to
spring strut (2).
•
Remove the fastener securing the angled lever to
frame (1) and remove the angled lever.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
L
Note:
Grease needle bearings with Shell Retinax EP2.
X
Tightening torques:
Angled lever to frame ................................... 50 Nm
Angled lever to spring strut .......................... 47 Nm
Angled lever to strut ..................................... 71 Nm
33.10
1 2
3
E330060
Removing and installing
33 53 610
needle roller bearings and needle
roller races in angled lever
Removing needle roller bearings and needle
roller races
– Remove angled lever.
11
10
9
•
Remove bearing bushings (4, 11, 10).
•
Lever out sealing rings (6, 7) with screwdriver.
L
Note:
To facilitate removal, heat the angled lever to 100 °C
(212 °F).
Use temperature measuring device,
BMW No. 00 1 900, to check heat rise.
•
Drive out needle roller bearings (8, 9) with drift,
BMW No. 33 6 620.
4
5
6
8
7
F330170
33 6 620
F330180