GE MiCOM P40 Agile Technical Manual page 445

Commissioning
MiCOM P40 Agile P442, P444
Note 1:
Monitoring can also be selected to poll the network parameters (I/U/P/Q/f...)
Note 2:
Note 3:
Note 4:
Check the measurement reference (ref. angle of phase shift) in:
"Measurt set up/Measurement ref." (VA by default).
In LCD: IN=3I0
After this step, the errors on the phase sequences, ratios of CT, VT and wiring
(analogue input only) will be detected.
See connections drawing
See LCD structure in test tools
P44x/EN CM/Hb6
(CM) 9-21