3Com WX1200 Reference Manual page 66

66 C 4: W
HAPTER ORKING WITH
N P
ETWORK LANS
9 In the HTTP Port Number box, specify the port number for HTTP service.
10 Click Next.
11 In the AP Model drop-down list, select one of the following:
AP (Dual Radio)—802.11a and 802.11b or 802.11b/g
AP (Single Radio)—802.11a, 802.11b, or 802.11g
12 In the Radio Type drop-down list, select one of the following: 11a, 11b,
11g.
The choices available depend on the selection you made in step 11.
13 Click Next.
14 Verify the radio slot number and radio type.
For a dual-radio access point, 802.11b/g radios have a slot number of 1.
802.11a radios have a slot number of 2.
15 In the Channel Number list, select the channel number for the radio.
16 In the Transmit Power box, specify the transmit power for the radio.
17 To enable the radio, select Enabled.
The access point's radio must be enabled in order to be considered in
channel allocation.
18 In the SSID box, type the service set identifier (SSID) for the radio.
19 In the MAC Address box, type the MAC address of the radio.
20 In the Antenna Gain list, select the antenna gain for the radio.
21 If the access point has only one radio, click Finish. Otherwise, go to
step 22.
22 Click Next. The Radio A page appears.
23 Repeat step 14 through step 20 for the 802.11a radio.
24 Click Finish to save the changes.
25 To place the AP on a floor plan, see "Moving a Third-Party AP Icon to its
Floor Location" on page 133.