3Com WX1200 Reference Manual page 194

194 C 6: C
HAPTER ONFIGURING
WX S P
YSTEM ARAMETERS
2 Specify the target ID.
3 Type the IP address of the target.
4 Specify the protocol port on which the target listens for SNMP
notifications. The default is 162.
5 Click Next.
6 Select the notification profile that will use this target.
To view the profile's notification types, or to enable or disable notification
types:
a Click Properties.
b Click the checkbox next to each notification type you want to enable
disable. To enable or disable all notification types, click the Enable
checkbox at the top of the list.
To create a new profile:
a Select Create new Notification Profile and click Next.
b In the Profile Name box, type the name of the notification profile. The
name can be 1 to 32 alphanumeric characters, with no spaces or tabs.
c Click Next.
d Click the checkbox next to each notification type you want to enable.
To enable all notification types, click the Enable checkbox at the top of
the list.
e Click Next.
7 From the Security Model drop-down list, select the SNMP version.
8 For USM (SNMPv3), select the security type:
Unsecured—SNMP message exchanges are not secure. This is the
default, and is the only value supported for SNMPv1 and SNMPv2c.
(This security level is the same as the noAuthNoPriv level described in
SNMPv3 RFCs.)
Authenticated—SNMP message exchanges are authenticated but
are not encrypted. (This security level is the same as the authNoPriv
level described in SNMPv3 RFCs.)
Encrypted—SNMP message exchanges are authenticated and
encrypted. (This security level is the same as the authPriv level
described in SNMPv3 RFCs.)