Example 2: Deployment Site Has No Dhcp And No Dns - 3Com WX1200 Reference Manual

Example 2:
Deployment Site Has
No DHCP and No DNS
3 Enable the auto-config option:
WX1200# set auto-config enable
success: change accepted.
4 Save the configuration changes:
WX1200# save config
success: configuration saved.
5 Power off or restart the switch.
The deployment site in this example does not have a DHCP server or a
local DNS server. Therefore, IP and DNS information must be statically
configured. Because no DNS server is available, an IP alias is configured to
map the IP address of the host where 3WXM Services are installed to the
well-known hostname wlan-config-srv.
1 Configure a VLAN:
WX1200# set vlan 1 port 7
success: change accepted.
2 Configure an IP interface on the VLAN.
WX1200# set interface 1 ip 192.168.1.252 255.255.255.0
success: change accepted.
3 Configure a default route through the local gateway:
WX1200# set ip route default 192.168.1.1 1
success: change accepted.
4 Configure the default DNS domain name:
WX1200# set ip dns domain example.com
Domain name changed
5 Configure an IP alias to map the 3WXM server IP address to the
well-known name wlan-config-srv:
WX1200# set ip alias wlan-config-srv 172.16.22.84
6 Enable the auto-config option:
WX1200# set auto-config enable
success: change accepted.
7 Save the configuration changes:
WX1200# save config
success: configuration saved.
8 Power off or restart the switch.
Staging a WX Switch for Configuration by 3WXM 339