3Com WX1200 Reference Manual page 231

4 Select the mapping type:
To map to a physical port, select port and go to step 5.
To map to a virtual port, select vport and go to step 6.
To map to a VLAN, select vlan and go to step 7.
To map to a Distributed MAP, select dap and go to step 8.
5 To map an ACL to a port:
a In the Port list, select the port or port group to which you want to map
the ACL.
You cannot map an ACL to a MAP port or a wired authentication
port.
b In the Direction list, select In to filter incoming packets or Out to filter
outgoing packets.
c Click Finish.
6 To map an ACL to a virtual port:
a In the Tag Value box, specify the 802.1Q tag value that identifies a
virtual port in a VLAN.
The tag value can be a number from 1 to 4093. The default value is 1.
Make sure that you do not specify duplicate mappings that specify the
same port and tag value.
b In the port list, select the port to which you want to map the ACL.
You cannot map an ACL to a MAP port or a wired authentication port.
c In the Direction list, select In to filter incoming packets or Out to filter
outgoing packets.
7 To map an ACL to a VLAN:
a In the Type list, select ID to identify the VLAN by number or Name to
identify it by name.
If you selected Name, select or type the VLAN name from the
Name drop-down list.
If you selected ID, select or type the VLAN number in the ID box.
b In the Direction list, select In to filter incoming packets or Out to filter
outgoing packets.
8 To map an ACL to a Distributed MAP:
a In the DAP ID list, select the Distributed MAP from the list.
Viewing and Configuring ACLs 231