Toolbar Options; Filtering The Message List; Resolving An Error Or Warning - 3Com WX1200 Reference Manual

366 C 11: V
HAPTER ERIFYING

Toolbar Options

Filtering the Message
Resolving an Error
or Warning
C C
ONFIGURATION
Details about the selected error or warning appear in the lower left
section of the tab.
The Resolution section of the tab lists options for resolving the warning or
error.
Table 27 lists the options on the Event tab's toolbar.
Table 27 Toolbar Options on Verification Tab
Option
Options
By default, all warning and error messages are listed. You can use the
List following options to filter the message list:
Show Errors—Error messages are listed only when this option is
selected.
Show Warnings—Warning messages are listed only when this option
is selected.
Show Disabled—Disabled rules are listed only when this option is
selected. (See "Disabling a Rule from the Message List" on page 367.)
For most errors and warnings, 3WXM provides a link to edit the
configuration information that caused the error or warning. The link
appears in the Resolutions section of the tab, under the Messages
column. When you click the edit link, 3WXM opens the configuration
wizard for the configuration item.
For example, if you create a new WX switch called dang-wxr100 but you
do not specify the system IP address of the switch, the error message
System IP address is not assigned or is invalid appears in the Message
area. To correct the error, click on Edit dang-wxr100 in the Resolutions
section. The Modify WX switch wizard appears. Use the wizard to edit
the System IP address. After you save the configuration change, 3WXM
reevaluates the switch's configuration. If the system IP address is
specified, the error no longer appears in the Verification tab.
HANGES
Description
Displays the Verification Options dialog box, which enables you to
change verification options and disable or reenable rules. (See
"Changing Verification Options" on page 368.)