Configuring Feature Settings In A Policy; Applying Policy Changes To Switches - 3Com WX1200 Reference Manual

Configuring
Feature Settings in
a Policy
Applying Policy
Changes to
Switches
To configure feature settings in a policy:
1 If you have not already done so, use the procedure in "Creating a Policy"
on page 376 to configure a policy and select the switches to which you
want to apply the policy.
2 In the Organizer panel, select a feature area.
3 Use the Content panel or wizards accessed from the Task List panel to
configure settings for the feature category.
To find information about a feature category, see Table 28 on page 378.
4 Click Save to save the changes to the policy.
5 In the Task List panel, select View to display the switches to which the
policy change will apply.
6 Only the settings you change from their default values are listed.
7 After you review the changes, click Close.
8 Correct any changes if needed, then go to "Applying Policy Changes to
Switches".
To apply policy changes to WX switches:
1 Select Apply in the Task List panel to apply the changes to WX switches
that are already associated with the policy.
2 Review the list of switches, then click Apply to apply the changes to the
switches.
The changes are automatically applied to switches you associate with the
policy after making the changes.
3 After the done message appears in the Apply Policy wizard, click Close.
4 Repeat step 2 through step 3 for each feature category.
Table 28 on page 378 lists the section where you can find configuration
information for a feature category.

Configuring Feature Settings in a Policy

377