Table of Contents
Advertisement
MM4006
1.4
System Setup
c v
N e v v p o r t .
1
This section covers motion control system set up and preparing use it.
First all necessary cables must be connected and the controller must be
properly configured. This set up procedure configures a minimal system,
similar to Fig. 1.11.
If you have not already done so, carefully unpack and visually inspect
the controllers and stages. Please save the packing material, in case you
have to ship the controller in the future.
Place all components on a flat and clear work surface. Check visually for
any sign of damage and if found, report immediately to the carrier.
The front two "legs" of the chassis have a tab that, if rotated 90° forward,
place the controller in a slightly angled position. To return the controller
to horizontal position, lift the front side, pull on the tabs and return
them to the original position.
No cables should be connected yet to the controller.
1.4.1 C o n n e c t i n g Motion Devices
If you purchased a standard motion control system, you should have
received all necessary hardware to set it up.
First connect the motion device (stage) interface cables. These are 10-ft-
long (3-m) cables with 25-pin to 25-pin D-Sub connectors. Insert them gen-
.
2
5
Fig. 1.11 — A minimal control system.
NOTE
NOTE
CAUTION
Introduction
EIM10181En1020-03/03
Advertisement
Chapters
Table of Contents
