AudioCodes Mediant 800B User Manual page 1055

User's Manual
Parameter
Precedence Ringing Type
precedence-ringing
[PrecedenceRingingType]
e911-mlpp-bhvr
[E911MLPPBehavior]
resource-prio-req
[RPRequired]
Multiple Differentiated Services Code Points (DSCP) per MLPP Call Priority Level (Precedence)
Parameters
The MLPP service allows placement of priority calls, where properly validated users can preempt
(terminate) lower-priority phone calls with higher-priority calls. For each MLPP call priority level, the
DSCP can be set to a value from 0 to 63. The Resource Priority value in the Resource-Priority SIP
header can be one of the following:
MLPP Precedence Level
0 (lowest)
2
4
6
8
9 (highest)
RTP DSCP for MLPP Routine
dscp-4-mlpp-rtn
[MLPPRoutineRTPDSCP]
RTP DSCP for MLPP Priority
Version 7.0
"000000".
Note: The parameter is applicable only to the MLPP NI-2 ISDN
variant with CallPriorityMode set to 1.
Defines the index of the Precedence Ringing tone in the Call
Progress Tones (CPT) file. This tone is used when the
parameter CallPriorityMode is set to 1 and a Precedence call is
received from the IP side.
The valid range is -1 to 16. The default is -1 (i.e., plays standard
ringing tone).
Note: The parameter is applicable only to analog interfaces.
Defines the E911 (or Emergency Telecommunication
Services/ETS) MLPP Preemption mode:

[0] = (Default) Standard Mode - ETS calls have the highest
priority and preempt any MLPP call.

[1] = Treat as routine mode - ETS calls are handled as
routine calls.
Note: The parameter is applicable only to analog interfaces.
Determines whether the SIP resource-priority tag is added in the
SIP Require header of the INVITE message for Tel-to-IP calls.

[0] Disable = Excludes the SIP resource-priority tag from the
SIP Require header.

[1] Enable = (Default) Adds the SIP resource-priority tag in
the SIP Require header.
Note: The parameter is applicable only to MLPP priority call
handling (i.e., only when the CallPriorityMode parameter is set
to 1).
Precedence Level in Resource-Priority SIP Header
routine
priority
immediate
flash
flash-override
flash-override-override
Defines the RTP DSCP for MLPP Routine precedence call level.
The valid range is -1 to 63. The default is -1.
Note: If set to -1, the DiffServ value is taken from the global
parameter PremiumServiceClassMediaDiffServ or as defined in
IP Profiles per call.
Defines the RTP DSCP for MLPP Priority precedence call level.
1055
61. Configuration Parameters Reference
Description
Mediant 800B Gateway and E- SBC