Connect Dc Power To The Cisco Asr 1013 Router - Cisco ASR 1013 Quick Start Manual

Figure 7 Cisco ASR 1013 Router AC Power Supply Power
5
4
AC power supply fan
1
DB-25 alarm connector
2
Tie-wrap tab
3
AC power supply captive screw
4
5 AC power supply handle
Shielded cables must be used to connect to the DB-25 alarm connector on both the AC and DC power supplies in
Note
order to comply with FCC/EN55022/CISPR22 Class A emissions requirements. See How Cisco ASR1000-RP Alarm
Monitoring Works, page 20.
Plug the AC power supply cable into the AC power source.
Step 3
This completes the procedure for connecting AC-input power .

Connect DC Power to the Cisco ASR 1013 Router

This section provides instructions for installing the DC power supply into the Cisco ASR 1013 Router. Read the safety warnings
before you begin.
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
6 7 8
100-240V~ 16-7A
50-60HZ
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
3
AC power inlet
6
AC power supply Standby switch
7
Protective shielding on both sides of the Standby switch
8
AC power supply LEDs
9
9
OUTPUT INPUT INPUT
FAIL OK OK
ALARMS
60V
1A MAX
2 1
15