Tieline ViA User Manual page 270

270 ViA User Manual v2.0
3. Follow the instructions on the right-hand side of the panel to configure the transport settings
for the connection, then click Next.
Important Note:
·
If you select Sessionless as the Session Protocol select UDP/IP +RTP for RFC-
compliant IP streaming.
·
See
Relays and RS232 Data
6. Configure destination codec dialing and encoding settings:
For IP connections configure the IP address, ports, and then specify which streaming
interface is used to dial this connection, e.g. Primary (port LAN1) or Secondary (port
LAN2). Note: By default Any will select LAN1 if it is available and LAN2 if it is unavailable.
Important Note: Important Note: The Remote Audio Port is the codec port at
the remote end of the link to which you are sending audio. The Local Audio Port
is used by the local codec to receive audio from the remote codec. When Tieline
Codecs is the Session Protocol selected (using Tieline session data), the default
port value for the Local Audio Port is Automatic. Note: Automatic indicates that
the codec will arbitrarily allocate the local port value and send this information to
the codec to which you are dialing. Click to deselect the Automatic check-box
and change this setting. When you select Sessionless as the Session Protocol,
the Session Port is not configurable and you can manually configure the Remote
Audio Port and Local Audio Port.
Session Port 9002 and Remote Audio Port 9000 are used by default for the first IP audio
stream. The audio for this audio steam will use analog or digital input and output 1 for both
the dialing and answering codecs. If you need to change default port settings on the codec
RS232 Data Configuration
for more information on relay operations.
for detailed information on RS232 data and see Enabling
© Tieline Pty. Ltd. 2017