Tieline ViA User Manual page 252

252 ViA User Manual v2.0
Dialing settings for this POTS audio stream are now complete.
Configuring a Failover Connection or Auto Reconnect
At this point in the wizard you can choose to configure Auto Reconnect or create a failover
connection for the audio stream you are configuring.
Important Note: When Auto Reconnect is enabled, the dialing codec will continue to
attempt a connection with the remote codec until Disconnect is pressed either on the
dialing codec's keypad, or in the Web-GUI.
1. Click to select the check-box for Create a Failover Connection. Adjust the parameters
and click Next.
The explanations within the following table can be used to assist with failover connection
configuration.
Screen Display
1 Threshold
2 Time Frame
3 Keep Alive
4 Failback Parameters
5 Stable Time
Description
The percentage of lost data measured during a given time
frame
The time frame against which lost data is measured
The keep connection alive time before failing over to a
backup connection; Tieline RTP pings every second to
confirm connectivity
Select the check-box to fail back to a higher priority
connection
The amount of time a primary connection must remain
stable before attempting to fail back from the backup
© Tieline Pty. Ltd. 2017