Napt Mode; Figure 35 Table 5-2 Nat Configuration Specification - UTStarcom WA3001 User Manual

68 Chapter 5 Web-based Configuration

Figure 35 Table 5-2 NAT Configuration Specification

Field
Enable NAT
NAT Mode
NAT Timeout
NAT Interface
inside
NAT Interface
outside
Configuration Description:
When NAT is enabled, select NAPT mode. Click <Apply> to
apply the configuration and click <Advanced> to take effect. For
more details, refer to the section 5.11.1 to configure the IP
address based mapping and port based mapping.
When NAT is enabled, select Basic mode. Click <Apply> to
apply the configuration and click <Advanced> to take effect.
User should configure the link between "NAT Pool" and "NAT
Static Map" based on port.

NAPT Mode

Access Method:
Description
Enable or Disable NAT
Two NAT modes are
available after enable NAT,
NAPT mode and Basic
NAT mode
NAT timeout options: 1-
3600 seconds
NAT Interface inside
NAT Interface outside
Default Value
Disable
NAPT
120
LAN Port
WAN port