142
Chapter 9 CLI Command Set
Access level: 2
Interface
Use this command to access the interface CONFIG level of the
CLI.
Syntax: interface ethernet {lan | wan}
Possible value: lan: Enters the LAN interface,
Access level: 2
IP Default-Route
Use the ip default-route global configuration command to
define a default gateway (router) when IP routing is disabled.
Syntax: ip default-route <ip-address>
no ip default-route
Possible value: ip-address: IP address of the router.
Default value: Disabled.
Access level: 2
wan: Enters the WAN interface.