180
Chapter 9 CLI Command Set
Explanation: Use this command to set wireless mode.
WDS-Mode Enable / Disable
Use this command to set the wireless card work mode: either
AP or WDS. When it is enabled, the wireless card supports
WDS mode
Use this command to set repeater work mode, either PTP or
PTMP. When it is enabled, the wireless card supports PTMP
mode and enables the WDS mode.
Syntax: wds-mode {<enable | disable> | <PTP|PTMP>}
Default value: disable
Access level: 2
Explanation: Use this command to enable/disable WDS mode
on this card.
WDS Peer MAC
Use this command to set toward AP MAC addresses based on
WDS mode, when PTMP is enabled, input 1-6 MAC addresses
for this wireless card
Syntax: wds peer mac <mac-address> [<mac-address> <mac-
address> <mac-address> <mac-address> <mac-address>]