148
Chapter 9 CLI Command Set
NAT Mode
Use this command to set NAT mode.
Syntax: nat mode {napt|basic}
Default value: napt
Access level:2
NAT Pool
Use this command to configure address pool for dynamic NAT.
Syntax: [no] nat pool <start-ip> <ip-mask>
Possible value:
start-ip: Specifies the IP address at the beginning of the pool
range.
ip-mask: Specifies the network mask associated with the
address pool.
Access level: 2
NAT Redirect
Use this command to configure static entry of host redirection
for NAPT.