Dot1X Supplicant-Timeout - UTStarcom WA3001 User Manual

138 Chapter 9 CLI Command Set
Packets. Use the no form of this command to return to the
default setting. The authentication server notifies the back-end
authenticator each time it receives a transport layer packet.
When the back-end authenticator does not receive a notification
after sending a packet, the back-end authenticator waits for
certain time period (i.e. set time period) and then retransmits the
packet.
Syntax: dot1x server-timeout <seconds>
no dot1x server-timeout
Possible value: 1-65535s
Default value: 30s
Access level: 2
Explanation: Use this command to set dot1x server timeout.

Dot1x Supplicant-Timeout

Use this command to set the Back-End Authenticator-to-
Supplicant Retransmission Time for EAP-Request Frames. Use
the no form of this command to return to the default setting. The
supplicant notifies the back-end authenticator that the
authenticator received the EAP-request frame. When the back-
end authenticator does not receive this notification, the back-
end authenticator waits for certain time period (i.e. set time
period) and then retransmits the frame.