Isolation; Load-Balance Enable/Disable - UTStarcom WA3001 User Manual

144 Chapter 9 CLI Command Set
ipaddr: This parameter identifies the destination IP address of
the static route.
mask: This parameter identifies the destination prefix mask of
the static route.
next-hop: This parameter identifies the IP address of the next
hop that can be used to reach the network.
Access level: 2

Isolation

Use this command to set isolation between the subscribers. No
parameter means to isolate all.
Syntax: isolation [lan | lan-wlan | wlan ]
Access level: 2

Load-Balance Enable/Disable

Use this command to enable or disable the load balance.
Syntax: load-balance {enable|disable}
Access level: 2