DHCP-Client Trust
Use this command to set the trusted DHCP server IP addresses.
(Up to 5)
Syntax: [no] dhcp-client trust <ip-address>
Possible value: ip-address: IP address of DHCP server
Access level: 2
DHCP-Pool
Use the dhcp-pool global configuration command to configure
Dynamic Host Configuration Protocol (DHCP) address pool on
the DHCP Server and enter the domain's DHCP pool
configuration mode. Use the no form of this command to
remove the address pool.
Syntax: [no] dhcp-pool
Default value: DHCP address pools are not configured.
Access level: 2
DHCP-Server Host
Use this command to set the DHCP server's IP address when
DHCP relay is enabled; use the no form to delete the server.
Chapter 9 CLI Command Set
131