Table of Contents
Advertisement
134
Chapter 9 CLI Command Set
Possible value: <userid>: 1-256
Access level: 2
Explanation: Use this command to initialize the DOT1X
subscriber status.
Dot1x Max-Req
Use this command to set the maximum number of times that the
device sends an Extensible Authentication Protocol (EAP) –
(request /identity frame (no response is received)) before
restarting the authentication process. Use the no form of this
command to return to the default setting.
Syntax: dot1x max-req <count>
no dot1x max-req
Possible value: count: 1 - 2.
Default value: 2 times
Access level: 2
Dot1x Quiet-Period
Use this command to set the number of seconds that the switch
remains in the quiet state following a failed authentication
Advertisement
Table of Contents
