Mitsubishi Electric NZ2GF12A4-16D User Manual page 114

Initial setting description
The following table lists the initial settings of the I/O combined module.
Item
Input response time setting
Output HOLD/CLEAR setting
Cyclic data update watch time setting
Initial operation setting
Input OFF delay setting X0 to X7
Number of ON times integration function enable Y8 to YF
Fast logic setting Y8 to YB
Devices used by user
Device
X22
D145
D146
D147
M30 to M41
SB47
SW0A0.0
Setting procedure
Set the same contents from procedures 1 to 6 in the following section.
Page 107 Setting procedure
9 PROGRAMMING
112
9.4 Program Example for the Number of ON Times Integration Function
Description
1.0ms
CLEAR
200ms
Without initial processing
0
Enable
Disable
Description
Number of ON times clear switch
Number of ON times clear target device specification
Number of ON times integration value clear completed confirmation
Number of ON times clear target device specification clear
Contact for clearing the number of ON times
Own station baton pass status (master station)
Baton pass status (station No.1)
QX10 (X20 to X2F)