Download  Print this page

Wiring Of Ethernet Cable - Mitsubishi Electric NZ2GF12A4-16D User Manual

Cc-link ie field network waterproof/dustproof remote i/o module.
Hide thumbs

Advertisement

6.5

Wiring of Ethernet Cable

Connecting the Ethernet cable
■Connecting
*1 The time taken for the LINK LED to turn on after connection of the cable may vary. The LINK LED normally turns on in a few second.
However, if link-up processing is repeated due to a condition of a device on the line, the longer time may be required. If the LINK LED
does not turn on, refer to the following and take a corrective action.
Page 130 When the LINK LED turns off
1.
Power off the power supplies of the I/O module
and the external device.
2.
Insert an Ethernet cable connector into the I/O
module. Pay attention to the connector's
direction.
3.
Tighten the screw of the Ethernet cable.
4.
Power on the module.
5.
Power on the external device.
6.
Check that the LINK LED of the port into which
the Ethernet cable is connected is on.
6 INSTALLATION AND WIRING
6.5 Wiring of Ethernet Cable
6
*1
69

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric NZ2GF12A4-16D

Comments to this Manuals

Symbols: 0
Latest comments: