Download  Print this page

Mitsubishi Electric NZ2GF12A4-16D User Manual Page 25

Cc-link ie field network waterproof/dustproof remote i/o module.
Hide thumbs

Advertisement

NZ2GF12A4-16DE DC input module
Item
Station type
Number of input points
Rated input voltage
Rated input current
Isolation method
Max. number of simultaneous input points
ON voltage/ON current
OFF voltage/OFF current
Input resistance
OFF  ON
Input response time
ON  OFF
Input type
Withstand voltage
Insulation resistance
Protection degree
Wiring method for common
External interface
Module power supply
part
I/O part
Communication part
Applicable waterproof
For power supply
connector
For I/O
Y-branch connector
for I/O
For communications
Cyclic transmission
RX/RY points
RWr/RWw points
Communication cable
Module power supply
Voltage
Current
Short-circuit detection current of sensor power
supply
Weight
NZ2GF12A4-16DE
Remote device station
16 points
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
7mA TYP. (for 24VDC)
Non-isolation
100%
15VDC or more/3.5mA or more
8VDC or less/1.7mA or less
3.3k
0ms/0.5ms/1ms/1.5ms/5ms/10ms/20ms/70ms
(Initial setting: 10ms)
Negative common (source type)
500VAC for 1 minute between all DC external terminals and the ground
10M or higher between all DC external terminals and ground (500VDC insulation resistance tester)
IP67
16 points/common (2- to 4-wire, waterproof connector type)
7/8" waterproof connector, 5 pins, male (IN)/female (OUT)
M12 waterproof connector, 5 pins, female, A-code
M12 waterproof connector, 8 pins, female, X-code
Page 14 Recommended Connector List
16 points
12 points
An Ethernet cable that meets the 1000BASE-T standard:
Category 5e or higher (double shielded, STP), straight cable
24VDC (ripple rate: 5% or less) (Allowable voltage range: 20.4 to 28.8VDC)
220mA or less (24VDC, all points ON)
400mA or more/input connector
0.71kg
3 SPECIFICATIONS
3.2 I/O Module Specifications
3
23

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric NZ2GF12A4-16D

Comments to this Manuals

Symbols: 0
Latest comments: