Download  Print this page

Program Example For Checking The Fast Logic Enable Or Disable Status - Mitsubishi Electric NZ2GF12A4-16D User Manual

Cc-link ie field network waterproof/dustproof remote i/o module.
Hide thumbs

Advertisement

Program example for checking the fast logic enable or disable
status
This section describes the program for reading the fast logic enable status.
When the parameter setting of the fast logic function is completed and Remote READY (RWr0.b11) is on, the fast logic enable
status can be read.
System configuration
Q61P
Q10UDHCPU
QJ71GF11-T2
QX10
X23
(1) Network No.1
(2) Station No.1
■Assignment of link devices
The assignment of link devices is the same as that in the following section.
Page 105 Assignment of link devices
Programming condition
This program reads the enable status of Fast logic setting Y8 to YB of the I/O combined module.
Initial setting description
The initial setting contents are the same as those in the following section.
Page 115 Initial setting description
Devices used by user
Device
X23
D105
M25 to M28
SB47
SW0A0.0
W100.B
Setting procedure
Set the same contents from procedures 1 to 6 in the following section.
Page 107 Setting procedure
NG2GF12A42-16DT
(1)
(2)
Description
Fast logic enable status read switch
Fast logic enable status acquisition
Contact for reading the fast logic enable status
Own station baton pass status (master station)
Baton pass status (station No.1)
Remote READY (RWr0.b11)
QX10 (X20 to X2F)
9 PROGRAMMING
9.5 Program Example for the Fast Logic Function
9
117

Advertisement

Table of Contents

   Related Manuals for Mitsubishi Electric NZ2GF12A4-16D

Comments to this Manuals

Symbols: 0
Latest comments: