Program Example for the Fast Logic Function
This section describes the program examples for when the fast logic function is used.
Turning off the module power supply changes the value in Fast logic setting Y (address: 0120H to 0127H) to the default
value (Disable (0)). (The parameter is not stored in the nonvolatile memory.)
Thus, when the fast logic function is set with a program, not by the parameter setting of an engineering tool, the parameter
can be set again easily.
Program example for the fast logic function
(1) Network No.1
(2) Station No.1
■Assignment of link devices
The assignment of link devices is the same as that in the following section.
Page 105 Assignment of link devices
When both X0 and X1 of the I/O combined module turn on, Y8 is turned on. When both X2 and X3 of the I/O combined
module turn on, Y9 is turned on.
9.5 Program Example for the Fast Logic Function