Filling Oil - APRILIA SL 750 SHIVER Service Station Manual

Suspensions
•
Screw the specific perforated rod on
the pumping member threaded rod.
Specific tooling
AP8140150 Perforated rod for pumping mem-
ber air bleed
•
Fit the centring plate.
•
Fit the pumping member together with
the centring plate in the sleeve.
•
Insert the special washer in the screw.
•
Tighten the screw to the prescribed tor-
que.
UPON REFITTING, REPLACE THE SAFETY
WASHER WITH A NEW ONE.
Locking torques (N*m)
Screw fixing the stem in wheel carrier -
M10x1.5 (2) 20 Nm (14.75 lbf ft)

Filling oil

NOTE
THE OPERATIONS DESCRIBED BELOW ARE VALID FOR BOTH STEMS.
•
Place the fork stem on a work table in upright position.
•
Fill the sleeve with the adequate quality and type of oil indicated on the recommended prod-
ucts table.
WARNING
MOVE THE PUMPING ELEMENT SEVERAL
TIMES UNTIL AIR BUBBLES ARE SEEN ON
THE OIL SURFACE.
THE SLEEVE MUST BE PERFECTLY VERTI-
CAL FOR A CORRECT OIL LEVEL MEASURE-
MENT. THE OIL LEVEL MUST BE THE SAME IN
BOTH STEMS.
Characteristic
Fork oil quantity (for each stem):
535 cm³ (32.65 cu.in)
SUSP - 16
SL 750 SHIVER