Parallel Output Settings (Output Config Menu); Assigning A Gpi Output Port - Sony MVS-8000 User Manual

Parallel Output Settings (Output Config
Menu)
For the DCU parallel output ports, after carrying out tally settings in the
Router/Tally >Tally Enable menu, you can assign GPI outputs to output ports
that are still unused.
To assign DCU outputs to DCU parallel output ports, display the DCU >Output
Config menu.
To display the Output Config menu
In the Engineering Setup menu, select VF5 'DCU' and HF3 'Output Config.'
The status area shows output port information.

Assigning a GPI Output Port

1
In the DCU >Output Config menu, select what the setting applies to
(DCU1 or DCU2) from the <DCU Select> group.
2
In the <Parallel Output Assign> group, press [GPI Output].
3
Using any of the following methods, select the output port and GPI output
number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob
1
2
5
a) When the MKS-2700 is connected, select 2.
b) When the MKS-2700 is connected, select a value in the range 1 to 36.
4
To confirm the selected setting, press [GPI Output Set].
This confirms the selection, which is reflected in the status area.
Parameter
Parallel Output Slot
Parallel Output Port
GPI Output

Parallel Output Settings (Output Config Menu)

Adjustment Setting values
Output port slot
2 to 6
Output port
1 to 54
GPI output 1 to 50
a)
b)
1271