Table of Contents
Advertisement
selection made in step 2 when the input is low, press
[L Set].
This confirms the setting, which appears in the status
area.
To Set the Level for the Format Converter
1
Set "System Format" for "Action" using the same
operation in Step 4 of "Making DCU GPI Input
Settings" (page 641).
The format converter list appears.
2
Select the format converter that you want to set from
the list.
3
In the <FC Input/Output> group, press [H Set] or [L
Set] to set the high level or low level, respectively.
Parallel Output Settings
(Output Config Menu)
For the DCU parallel output ports, after carrying out tally
settings in the Router/Tally >Tally Enable menu, you can
assign GPI outputs to output ports that are still unused.
To display the Output Config menu
In the Engineering Setup menu, select VF5 'DCU' and
HF3 'Output Config.'
The status area shows output port information.
Assigning a GPI Output Port
1
In the DCU >Output Config menu, select what the
setting applies to (DCU1 or DCU2) from the <DCU
Select> group.
2
In the <Parallel Output Assign> group, press [GPI
Output].
3
Using any of the following methods, select the output
port and GPI output number.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment
1
Parallel
Output port slot
Output Slot
2
Parallel
Output port
Output
Port
5
GPI Output GPI output
a) When the MKS-2700 is connected, select 2.
b) When the MKS-2700 is connected, select a value in the range 1 to 36.
4
To confirm the selected setting, press [GPI Output
Set].
This confirms the selection, which is reflected in the
status area.
Parallel Output Settings (Output Config Menu)
Setting values
a)
2 to 6
b)
1 to 54
1 to 50
643
Advertisement
Table of Contents
