Table of Contents
Advertisement
D
EFAULT
19
C
OMMAND
Interface Configuration
C
OMMAND
◆
◆
E
XAMPLE
AP(if-wireless a)#bridge-link path-cost 1 50
AP(if-wireless a)#
Use this command to configure the priority for the specified port.
bridge-link port-
priority
S
YNTAX
D
EFAULT
128
C
OMMAND
Interface Configuration
C
OMMAND
◆
◆
E
XAMPLE
AP(if-wireless a)#bridge-link port-priority 1 64
AP(if-wireless a)#
S
ETTING
M
ODE
U
SAGE
This command is used by the Spanning Tree Protocol to determine the
best path between devices. Therefore, lower values should be assigned
to ports attached to faster media, and higher values assigned to ports
with slower media.
Path cost takes precedence over port priority.
bridge-link port-priority <index> <priority>
index - Specifies the bridge link number on the wireless bridge.
(Range: 1-6 required on wireless interface only)
priority - The priority for a port. (Range: 1-255)
S
ETTING
M
ODE
U
SAGE
This command defines the priority for the use of a port in the Spanning
Tree Protocol. If the path cost for all ports on a wireless bridge are the
same, the port with the highest priority (that is, lowest value) will be
configured as an active link in the spanning tree.
Where more than one port is assigned the highest priority, the port with
lowest numeric identifier will be enabled.
– 199 –
| Ethernet Interface Commands
C
25
HAPTER
Advertisement
Table of Contents
