Table of Contents
Advertisement
D
EFAULT
Interface enabled
C
OMMAND
Interface Configuration (Wireless-VAP)
C
OMMAND
You must first enable VAP interface 0 before you can enable VAP interfaces
1, 2, 3, 4, 5, 6, or 7.
E
XAMPLE
AP(if-wireless g: VAP[0])#shutdown
AP(if-wireless g)#
This command displays the status for the wireless interface.
show interface
wireless
S
YNTAX
show interface wireless <a | g> vap-id
C
OMMAND
Exec
E
XAMPLE
AP#show interface wireless g 0
Wireless Interface Information
=========================================================================
----------------Identification-------------------------------------------
Description
SSID
Channel
Status
MAC Address
----------------802.11 Parameters----------------------------------------
Radio Mode
Protection Method
Transmit Power
Max Station Data Rate
Multicast Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
Authentication Timeout Interval : 60 Mins
Association Timeout Interval
DTIM Interval
Preamble Length
Maximum Association
S
ETTING
M
ODE
U
SAGE
a - 802.11a radio interface.
g - 802.11g radio interface.
vap-id - The number that identifies the VAP interface. (Options:
0~7)
M
ODE
– 215 –
| Wireless Interface Commands
C
26
HAPTER
: Enterprise 802.11g Access Point
: SMC_VAP_G 0
: 1 (AUTO)
: ENABLED
: 00:03:7f:fe:03:02
: b & g mixed mode
: CTS only
: FULL (16 dBm)
: 54Mbps
: 5.5Mbps
: 2346 bytes
: 2347 bytes
: 100 TUs
: 30 Mins
: 1 beacon
: LONG
: 64 stations
Advertisement
Table of Contents
