Bridge Stp Br-Conf Max-Age - SMC Networks EliteConnect SMCE21011 User Manual

| Spanning Tree Commands
C 23
HAPTER
bridge stp br-conf
max-age
bridge stp br-conf
priority
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command sets the time interval (in seconds) at which the root device
transmits a configuration message.
E
XAMPLE
AP(config)#bridge stp br-conf hello-time 5
AP(config)#
Use this command to configure the spanning tree bridge maximum age
globally for the wireless bridge. Use the no form to restore the default.
S
YNTAX
bridge stp br-conf max-age <seconds>
no bridge stp br-conf max-age
seconds - Time in seconds. (Range: 6-40 seconds)
The minimum value is the higher of 6 or [2 x (hello-time + 1)].
The maximum value is the lower of 40 or [2 x (forward-time - 1)].
D S
EFAULT ETTING
20 seconds
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command sets the maximum time (in seconds) a device can wait
without receiving a configuration message before attempting to
reconfigure. All device ports (except for designated ports) should receive
configuration messages at regular intervals. Any port that ages out STP
information (provided in the last configuration message) becomes the
designated port for the attached LAN. If it is a root port, a new root port is
selected from among the device ports attached to the network.
E
XAMPLE
AP(config)#bridge stp max-age 40
AP(config)#
Use this command to configure the spanning tree priority globally for the
wireless bridge. Use the no form to restore the default.
– 188 –