Table of Contents
Advertisement
| System Management Commands
C
13
HAPTER
System Management Commands
ip https port
ip https server
Use this command to specify the UDP port number used for HTTPS/SSL
connection to the access point's Web interface. Use the no form to restore
the default port.
S
YNTAX
ip https port <port_number>
no ip https port
port_number – The UDP port used for HTTPS/SSL.
(Range: 80, 1024-65535)
D
S
EFAULT
ETTING
443
C
M
OMMAND
ODE
Global Configuration
C
U
OMMAND
SAGE
You cannot configure the HTTP and HTTPS servers to use the same
◆
port.
To avoid using common reserved TCP port numbers below 1024, the
◆
configurable range is restricted to 443 and between 1024 and 65535.
If you change the HTTPS port number, clients attempting to connect to
◆
the HTTPS server must specify the port number in the URL, in this
format:
https://device:port_number
E
XAMPLE
AP(config)#ip https port 1234
AP(config)#
Use this command to enable the secure hypertext transfer protocol
(HTTPS) over the Secure Socket Layer (SSL), providing secure access (i.e.,
an encrypted connection) to the access point's Web interface. Use the no
form to disable this function.
S
YNTAX
ip https server
no ip https server
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Global Configuration
– 134 –
Advertisement
Table of Contents
