Table of Contents
Advertisement
| Wireless Interface Commands
C
26
HAPTER
preamble
ath_vdrv: Version 0.1
All Rights Reserved
ieee80211_ioctl_setmode: CHH Mode: 11NGHT20
ath_set_config: Setting ATH parameter
ath_set_config: Setting ATH parameter
ath_set_config: Setting ATH parameter
ieee80211_ioctl_setparam: CHH Calling ieee80211_open
ieee80211_ioctl_setparam: CHH Calling ieee80211_open
ath_set_config: Setting ATH parameter
ath_set_config: Setting ATH parameter
ieee80211_ioctl_setparam: CHH Calling ieee80211_open
ieee80211_ioctl_setparam: CHH Calling ieee80211_open
ath_set_config: Setting ATH parameter
Force rf_pwd_icsyndiv to 1 on 2412 (1 0)
--AP ar5416InitUserSettings ahp->ah_miscMode 0xc
ar5416Reset Setting CFG 0x10a
Howl Revision ID 0xb9
MBSSID Set bit 22 of AR_STA_ID 0xb8c13054
Country ie is USI
Force rf_pwd_icsyndiv to 2 on 2462 (1 0)
--AP ar5416InitUserSettings ahp->ah_miscMode 0xc
ar5416Reset Setting CFG 0x10a
Howl Revision ID 0xb9
MBSSID Set bit 22 of AR_STA_ID 0xb8c13054
device ath0 entered promiscuous mode
br0: port 2(ath0) entering learning state
br0: topology change detected, propagating
br0: port 2(ath0) entering forwarding state
Add port ath0 to bridge br0 successfully
ath_vdrv: Version 0.1
All Rights Reserved
AP(if-wireless 0)#
This command sets the length of the signal preamble that is used at the
start of a 802.11b/g data transmission.
S
YNTAX
preamble [long | short-or-long]
long - Sets the preamble to long (192 microseconds).
short-or-long - Sets the preamble to short if no 802.11b clients
are detected (96 microseconds).
D
S
EFAULT
ETTING
Short-or-Long
C
M
OMMAND
ODE
Interface Configuration (Wireless - 802.11b/g)
C
U
OMMAND
SAGE
◆
Using a short preamble instead of a long preamble can increase data
throughput on the access point, but requires that all clients can support
a short preamble.
– 208 –
Advertisement
Table of Contents
