Radius Client Commands - SMC Networks EliteConnect SMCE21011 User Manual

19
radius-server enable
RADIUS C
Remote Authentication Dial-in User Service (RADIUS) is a logon
authentication protocol that uses software running on a central server to
control access for RADIUS-aware devices to the network. An authentication
server contains a database of credentials, such as users names and
passwords, for each wireless client that requires access to the access point.
Table 17: RADIUS Client Commands
Command Function
radius-server enable Enables the RADIUS server.
radius-server address Specifies the RADIUS server
radius-server port Sets the RADIUS server network port
radius-server key Sets the RADIUS encryption key
radius-server accounting Sets the RADIUS server accounting address
address
radius-server accounting Sets the RADIUS server accounting port
port
radius-server accounting Sets the RADIUS server accounting key
key
radius-server accounting Sets the interval between transmitting
timeout-interim accounting updates to the RADIUS server
show radius Shows the current RADIUS settings
This command enables the RADIUS server.
S
YNTAX
radius-server {primary | secondary} enable
primary - Specifies the primary RADIUS server.
secondary - Specifies the secondary RADIUS server.
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
E
XAMPLE
AP(config)# radius-server primary enable
This setting has not been effective !
– 170 –
C
LIENT OMMANDS
Mode Page
GC 170
GC 171
GC 171
GC 171
GC 172
GC 172
GC 173
GC 173
Exec 174