Snmp Commands - SMC Networks EliteConnect SMCE21011 User Manual

17
snmp-server
community
SNMP C
OMMANDS
Controls access to this access point from management stations using the
Simple Network Management Protocol (SNMP), as well as the hosts that
will receive trap messages.
Table 15: SNMP Commands
Command Function
snmp-server community Sets up the community access string to permit
access to SNMP commands
snmp-server contact Sets the system contact string
snmp-server location Sets the system location string
snmp-server enable Enables SNMP service and traps
server
snmp-server host Specifies the recipient of an SNMP notification
operation
snmp-server trap Enables specific SNMP notifications
snmp-server user Sets the name of the SNMP v3 user
snmp-server targets Configures SNMP v3 notification targets
snmp-server filter Configures SNMP v3 notification filters
show snmp users Displays SNMP v3 user settings
show snmp target Displays the SNMP v3 notification targets
show snmp filter Displays the SNMP v3 notification filters
show snmp Displays the status of SNMP communications
This command defines the community access string for the Simple Network
Management Protocol. Use the no form to remove the specified community
string.
S
YNTAX
snmp-server community string [ro | rw]
no snmp-server community string
string - Community string that acts like a password and permits
access to the SNMP protocol. (Maximum length: 23 characters, case
sensitive)
ro - Specifies read-only access. Authorized management stations
are only able to retrieve MIB objects.
rw - Specifies read/write access. Authorized management stations
are able to both retrieve and modify MIB objects.
– 154 –
Mode Page
GC 154
GC 155
GC 155
GC 156
GC 157
GC 157
GC 161
GC 162
GC 163
Exec 164
Exec 164
Exec 165
Exec 165