| System Settings
C
5
HAPTER
System Time
RADIUS A
CCOUNTING
S
T
YSTEM
IME
The following items are displayed on the RADIUS Settings page:
Account Status — Enables/disables RADIUS accounting.
◆
IP Address — Specifies the IP address or host name of the RADIUS
◆
accounting server.
◆
Port (1024-65535) — The UDP port number used by the RADIUS
accounting server for authentication messages. (Range: 1024-65535;
Default: 1812)
Key — A shared text string used to encrypt messages between the
◆
access point and the RADIUS accounting server. Be sure that the same
text string is specified on the RADIUS server. Do not use blank spaces
in the string. (Maximum length: 255 characters)
Interim Update Timeout (60-86400) — The interval between
◆
transmitting accounting updates to the RADIUS server. (Range: 60-
86400; Default: 3600 seconds)
Simple Network Time Protocol (SNTP) allows the access point to set its
internal clock based on periodic updates from a time server (SNTP or NTP).
Maintaining an accurate time on the access point enables the system log to
record meaningful dates and times for event entries. If the clock is not set,
the access point will only record the time from the factory default set at the
last bootup.
The access point acts as an SNTP client, periodically sending time
synchronization requests to specific time servers. You can configure up to
two time server IP addresses. The access point will attempt to poll each
server in the configured sequence.
– 58 –