Apmgmtui - SMC Networks EliteConnect SMCE21011 User Manual

| System Management Commands
C 13
HAPTER
System Management Commands

APmgmtUI

C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
If anyone tries to access a management interface on the access point
◆
from an invalid address, the unit will reject the connection, enter an
event message in the system log, and send a trap message to the trap
manager.
IP address can be configured for SNMP, web and Telnet access
◆
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
When entering addresses for the same group (i.e., SNMP, web or
◆
Telnet), the access point will not accept overlapping address ranges.
When entering addresses for different groups, the access point will
accept overlapping address ranges.
◆ You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
You can delete an address range just by specifying the start address, or
◆
by specifying both the start address and end address.
E
XAMPLE
This example restricts management access to the indicated addresses.
AP(config)#apmgmtip multiple 192.168.1.50 255.255.255.0
AP(config)#
This command enables and disables management access to the access
point through SNMP, Telnet and web interfaces.
Secure Web (HTTPS) connections are not affected by the UI
C :
AUTION
Management or IP Management settings.
S
YNTAX
APmgmtUI <[SNMP | Telnet | Web] enable | disable>
SNMP - Specifies SNMP management access.
Telnet - Specifies Telnet management access.
Web - Specifies web based management access.
enable/disable - Enables or disables the selected management
access method.
– 136 –