E
XAMPLE
AP(if-wireless g: VAP[0])#encryption
AP(if-wireless g)#
R
C
ELATED
OMMANDS
key (221)
This command sets the keys used for WEP encryption. Use the no form to
key
delete a configured key.
S
YNTAX
key <1-4> <static> <dynamic>
no key
1-4 - Key index. (Range: 1-4)
static - Indicates a static key.
dynamic - Indicates a dynamic key.
value - The key string.
For 64-bit keys, use 5 alphanumeric characters or 10 hexadecimal
digits.
For 128-bit keys, use 13 alphanumeric characters or 26
hexadecimal digits.
For 152-bit keys, use 16 alphanumeric characters or 32
hexadecimal digits.
D
S
EFAULT
ETTING
None
C
M
OMMAND
ODE
Interface Configuration (Wireless)
C
U
OMMAND
SAGE
◆
To enable Wired Equivalent Privacy (WEP), use the auth shared-key
command to select the "shared key" authentication type, use the key
command to configure at least one key, and use the transmit-key
command to assign a key to one of the VAP interfaces.
If WEP option is enabled, all wireless clients must be configured with
◆
the same shared keys to communicate with the access point.
◆
The encryption index, length and type configured in the access point
must match those configured in the clients.
E
XAMPLE
AP(if-wireless 0)#key 1 64 hex 1234512345
AP(if-wireless 0)#key 2 128 ascii asdeipadjsipd
C
27
HAPTER
– 221 –
| Wireless Security Commands