Snmp-Server Host - SMC Networks EliteConnect SMCE21011 User Manual

R
This command specifies the recipient of an SNMP notification. Use the no

snmp-server host

form to remove the specified host.
S
D
Host Address: None
Community String: public
C
Global Configuration
C
The snmp-server host command is used in conjunction with the snmp-
server enable server command to enable SNMP notifications. You can
configure up to four host IP addresses. A separate snmp-server host
command must be entered for each host.
E
R
snmp-server enable server (156)
This command enables the access point to send specific SNMP traps
snmp-server trap
(i.e., notifications). Use the no form to disable specific trap messages.
S
C
ELATED OMMANDS
snmp-server host (157)
YNTAX
snmp-server host <host_ip_address> <community-string>
no snmp-server host
host_ip_address - IP of the host (the targeted recipient).
community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you
define this string using the snmp-server community command
prior to using the snmp-server host command. (Maximum length:
23 characters)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
AP(config)#snmp-server host 1 10.1.19.23 batman
AP(config)#
C
ELATED OMMANDS
YNTAX
snmp-server trap <trap>
no snmp-server trap <trap>
– 157 –
| SNMP Commands
C 17
HAPTER