Table of Contents
Advertisement
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
C
U
OMMAND
SAGE
DHCP is enabled by default. To manually configure a new IP address,
◆
you must first disable the DHCP client with the no ip dhcp command.
You must assign an IP address to this device to gain management
◆
access over the network or to connect the access point to existing IP
subnets. You can manually configure a specific IP address using this
command, or direct the device to obtain an address from a DHCP server
using the ip dhcp command. Valid IP addresses consist of four
numbers, 0 to 255, separated by periods. Anything outside this format
will not be accepted by the configuration program.
E
XAMPLE
AP(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
Enterprise AP(if-ethernet)#ip address 192.168.1.2 255.255.255.0 192.168.1.253
AP(if-ethernet)#
R
C
ELATED
OMMANDS
ip dhcp (197)
This command enables the access point to obtain an IP address from a
ip dhcp
DHCP server. Use the no form to restore the default IP address.
S
YNTAX
ip dhcp
no ip dhcp
D
S
EFAULT
ETTING
Enabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
C
U
OMMAND
SAGE
You must assign an IP address to this device to gain management
◆
access over the network or to connect the access point to existing IP
subnets. You can manually configure a specific IP address using the ip
address command, or direct the device to obtain an address from a
DHCP server using this command.
When you use this command, the access point will begin broadcasting
◆
DHCP client requests. The current IP address (i.e., default or manually
configured address) will continue to be effective until a DHCP reply is
received. Requests will be broadcast periodically by this device in an
effort to learn its IP address. (DHCP values can include the IP address,
subnet mask, and default gateway.)
C
25
HAPTER
– 197 –
| Ethernet Interface Commands
Advertisement
Table of Contents
