Ethernet Interface Commands; Table 23: Ethernet Interface Commands - SMC Networks EliteConnect SMCE21011 User Manual

25
interface ethernet
E I
THERNET
The commands described in this section configure connection parameters
for the Ethernet port and wireless interface.

Table 23: Ethernet Interface Commands

Command Function
interface ethernet Enters Ethernet interface configuration mode GC
dns primary- server Specifies the primary name server
dns secondary- server Specifies the secondary name server
ip address Sets the IP address for the Ethernet interface IC-E
ip dhcp Submits a DHCP request for an IP address
shutdown Disables the Ethernet interface
bridge-link path-cost Configures the spanning tree path cost of a
port
bridge-link port- Configures the spanning tree priority of a
priority port
show interface Shows the status for the Ethernet interface
ethernet
This command enters Ethernet interface configuration mode.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
E
XAMPLE
To specify the 10/100Base-TX network interface, enter the following
command:
AP(config)#interface ethernet
AP(if-ethernet)#
– 195 –
C
NTERFACE OMMANDS
Mode Page
195
IC-E 196
IC-E 196
196
IC-E 197
IC-E 198
IC 198
IC 199
Exec 200