Bridge Stp Br-Conf Hello-Time - SMC Networks EliteConnect SMCE21011 User Manual

Use this command to configure the spanning tree bridge forward time
bridge stp br-conf
globally for the wireless bridge. Use the no form to restore the default.
forwarding-delay
S
D
15 seconds
C
Global Configuration
C
This command sets the maximum time (in seconds) the root device will
wait before changing states (i.e., discarding to learning to forwarding). This
delay is required because every device must receive information about
topology changes before it starts to forward frames. In addition, each port
needs time to listen for conflicting information that would make it return to
the discarding state; otherwise, temporary data loops might result.
E
Use this command to configure the spanning tree bridge hello time globally
bridge stp br-conf
for the wireless bridge. Use the no form to restore the default.
hello-time
S
D
2 seconds
AP(config)bridge stp service
AP(config)
YNTAX
bridge stp br-conf forwarding-delay <seconds>
no bridge stp br-conf forwarding-delay
seconds - Time in seconds. (Range: 4 - 30 seconds)
The minimum value is the higher of 4 or [(max-age / 2) + 1].
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
AP(config)#bridge stp br-conf forwarding-delay 20
AP(config)#
YNTAX
bridge stp br-conf hello-time <time>
no bridge stp br-conf hello-time
time - Time in seconds. (Range: 1-10 seconds).
The maximum value is the lower of 10 or [(max-age / 2) -1].
S
EFAULT ETTING
– 187 –
| Spanning Tree Commands
C 23
HAPTER