Lldp Transmit Interval - SMC Networks EliteConnect SMCE21011 User Manual

lldp-transmit hold-
muliplier
lldp transmit
interval
lldp transmit re-init-
delay
This command configures the length of time the access point will sustain its
LLDP signal on the network. (Default: 4 seconds; Range: 2-10 seconds)
S
YNTAX
lldp transmit hold-multiplier <seconds>
no link-integrity ping-host
seconds - Time in seconds.
(Range: 2-10 seconds)
D S
EFAULT ETTING
4 seconds
C M
OMMAND ODE
Global Configuration
E
XAMPLE
AP(config)# lldp transmit hold-multiplier 5
AP(config)#
The frequency with which the LLDP header is transmitted.
S
YNTAX
link transmit interval <interval>
interval - The time between with the LLDP header is transmitted.
(Range: 5-32768 seconds)
D S
EFAULT ETTING
30 seconds
C M
OMMAND ODE
Global Configuration
E
XAMPLE
AP(config)# lldp transmit interval 30
AP(config)#
Upon a reboot this parameter specifies the initial delay before which the
LLDP header is transmitted. (Default: 2 seconds; Range: 2-10 seconds)
S
YNTAX
lldp transmit re-init-delay <seconds>
seconds - Time in seconds. (Range: 2 - 10)
– 229 –
| Link Layer Discovery Commands
C 28
HAPTER