Flash /File Commands; Table 16: Flash/File Commands - SMC Networks EliteConnect SMCE21011 User Manual

18
dual-image
F /F
LASH ILE
These commands are used to manage the system code or configuration
files.

Table 16: Flash/File Commands

Command Function
dual-image Specifies the file or image used to start up the
system
copy Copies a code image or configuration between
flash memory and a FTP/TFTP server
show dual-image Displays the name of the current operation
code file that
booted the system
This command specifies the image used to start up the system.
S
YNTAX
dual-image boot image [a | b]
a/b - Specifies the image file to be used as a primary startup file.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Exec
C U
OMMAND SAGE
Specifies the name of the code file on the server. The new firmware file
◆
name should not contain slashes (\ or /), the leading letter of the file
name should not be a period (.), and the maximum length for file
names is 32 characters for files on the access point. (Valid characters:
A-Z, a-z, 0-9, ".", "-", "_")
If the file contains an error, it cannot be set as the default file.
◆
E
XAMPLE
AP# dual-image boot-image A
Change image to A
AP#
– 167 –
C
OMMANDS
Mode Page
GC 167
Exec 168
Exec 169