Table of Contents
Advertisement
| System Management Commands
C
13
HAPTER
System Management Commands
ip ssh-server port
ip telnet-server
enable
After boot up, the SSH server needs about two minutes to generate
◆
host encryption keys. The SSH server is disabled while the keys are
being generated. The show system command displays the status of
the SSH server.
E
XAMPLE
AP(if-ethernet)#ip ssh-server enable
AP(if-ethernet)#
This command sets the Secure Shell server port. Use the no form to
disable the server.
S
YNTAX
ip ssh-server port <port-number>
port-number - The UDP port used by the SSH server. (Range: 1-
65535)
D
S
EFAULT
ETTING
22
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
E
XAMPLE
AP(if-ethernet)#ip ssh-server port 1124
AP(if-ethernet)#
This command enables the Telnet server. Use the no form to disable the
server.
S
YNTAX
ip telnet-server enable
no ip telnet-server
D
S
EFAULT
ETTING
Interface enabled
C
M
OMMAND
ODE
Interface Configuration (Ethernet)
E
XAMPLE
AP(if-ethernet)#ip telnet-server enable
AP(if-ethernet)#
– 132 –
Advertisement
Table of Contents
