Figure 27: System Log Settings - SMC Networks EliteConnect SMCE21011 User Manual

Figure 27: System Log Settings

The following items are displayed on this page:
syslog status — Enables/disables the logging of error messages.
◆
(Default: enabled)
Server 1~4 — Enables the sending of log messages to a Syslog server
◆
host. Up to four Syslog servers are supported on the access point.
(Default: disabled)
◆ IP — The IP address or name of a Syslog server. (Server 1 Default:
10.7.16.98; Server 2 Default: 10.7.13.48; Server 3 Default:
10.7.123.123; Server 4 Default: 10.7.13.77)
UDP Port — The UDP port used by a Syslog server. (Range: 514 or
◆
11024-65535; Server 1~2 Default: 514; Server 3 Default: 6553;
Server 4 Default: 5432)
◆ Logging Console — Enables the logging of error messages to the
console. (Default: disabled)
Logging Level — Sets the minimum severity level for event logging.
◆
(Default: Debug)
The system allows you to limit the messages that are logged by
■
specifying a minimum severity level. The following table lists the
error message levels from the most severe (Emergency) to least
– 63 –
| System Settings
C 5
HAPTER
System Logs