Wmm Commands; Table 28: Wmm Commands - SMC Networks EliteConnect SMCE21011 User Manual

30
wmm
WMM C
OMMANDS
The access point implements QoS using the Wi-Fi Multimedia (WMM)
standard. Using WMM, the access point is able to prioritize traffic and
optimize performance when multiple applications compete for wireless
network bandwidth at the same time. WMM employs techniques that are a
subset of the developing IEEE 802.11e QoS standard and it enables the
access point to inter-operate with both WMM- enabled clients and other
devices that may lack any WMM functionality.
The WMM commands supported by the access point are listed below.

Table 28: WMM Commands

Command Function
wmm Sets the WMM operational mode on the access
point
wmm-acknowledge- Allows the acknowledgement wait time to be
policy enabled or disabled for each Access Category
(AC)
wmmparam Configures detailed WMM parameters that
apply to the access point (AP) or the wireless
clients (BSS)
This command sets the WMM operational mode on the access point. Use
the no form to disable WMM.
S
YNTAX
[no] wmm <required>
required - WMM must be supported on any device trying to
associated with the access point. Devices that do not support this
feature will not be allowed to associate with the access point.
D
EFAULT
supported
C M
OMMAND ODE
Interface Configuration (Wireless)
E
XAMPLE
AP(if-wireless a)#wmm required
AP(if-wireless a)#
– 235 –
Mode Page
IC-W 235
IC-W 236
IC-W 236